12-14-2008 11:20 AM - edited 03-04-2019 12:42 AM
A quick question, I'm trying to run IS-IS over frame relay studying for my CCNP on a Cisco 1750 Ver 12.1,
The "Router isis" command doesn't put me in the router config mode, does it mean that ISIS is not supported on this router ?
12-15-2008 07:33 PM
Hi,
I ran in to a similar problem myself in my studies a few weeks ago. You can tab the is-is commands but when you hit enter nothing happens.
You need a later IOS (12.3 I think)
Check out http://tools.cisco.com/ITDIT/ISTMAIN/servlet/index (search by product) to find out which release is most appropriate.
I hope that helps!
Phil
12-16-2008 08:48 AM
I quick question, do you have to pay to download the latest IOS ? Because I find it, but can't download it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: