Option1 - if you have the Ip block currently assigned by ARIN which allows you to have and ISP announce the public IP you can have the ISP that is currently routing your 67.70.247.xxx IP block via Cisco 1841 to stop routing that block and at the same time ask ISP for internet A to route that block via ASA5510 in conjunction with 206.162.188.xxx IP block, then in the ASA5510 you can re-create static NAT and rules for your mail services using the 67.70.247.xxy ip address ALL via 206.162.188.XXX gateway. ( in this scenario you will completely shut down the 1841 router and Internet B ISP )
Optoin2 -in Cisco 1841 routerhave PBR configure for the mail server 172.16.220.26 to use ASA5510 as its next hop router for outbound traffic and still maintain inbound mail services via Cisco 1841 IP 67.70.247.xxy
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...