Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

ISP/VPN Failover Configure works but not Load Sharing

Hi,

I have configure ISP/VPN failover & it works perfectly when ever my primary ISP fails. But I am not able to utilize my 2nd ISP when I do a static NAT when the Primary ISP is up. How can I make use of utilizing both the ISP's when I configure for ISP/VPN failover configuration?

3 REPLIES
Hall of Fame Super Silver

Re: ISP/VPN Failover Configure works but not Load Sharing

Hello Ananda,

look at the load balancing section

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091c8a.shtml#wp30811

Hope to help

Giuseppe

Re: ISP/VPN Failover Configure works but not Load Sharing

Thanks for the reply, but how do I achieve this on my Cisco ASA?

Hall of Fame Super Silver

Re: ISP/VPN Failover Configure works but not Load Sharing

Hello Ananda,

NAT with DNS doctoring could help see

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807968c8.shtml

Hope to help

Giuseppe

128
Views
0
Helpful
3
Replies
CreatePlease to create content