Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISR 3845 with PRI, PVDM and HWIC

Hi everybody,

i got following infrastructure;

ISR 3845 with IOS 12.4.10a, including NM-1CE1T1-PRI,PVDM2-24DM and HWIC-8A/S-232

I have to setup following configurations:

1. Depending on the incoming calling number on the PRI interface, i have to path through the connection to a dedicated RS232 port of the HWIC module.

2. I have to setup a ISDN call initiated from a system connected on the HWIC module.

Question:

Can somebody help me concerning the configuration of these two setups.

Thank you very much in advance

regards

stephan

4 REPLIES
Hall of Fame Super Gold

Re: ISR 3845 with PRI, PVDM and HWIC

You will need to know what are the network protocols used on these calls, to terminate, route or translate them.

Although STUN support transparent transport of synchronous streams from one port to another, it does not support switched/ISDN calls, only predefined serial interfaces.

New Member

Re: ISR 3845 with PRI, PVDM and HWIC

Sorry for the bad delay. I' try to get detailed information from customer side. Unfortunately without success so far. I guess the network protocol will be IP. But i like to confirm this from customer side.

regards

stephan

New Member

Re: ISR 3845 with PRI, PVDM and HWIC

Attached you'll find the diagram.

regards

stephan

New Member

Re: ISR 3845 with PRI, PVDM and HWIC

There are 2 types of repeater: 2nd and 3rd generation.

- Communication 2nd generation repeaters, even if modem based is proprietary, non-network-based, 7bit ACSII VT100 and clearly application dedicated nature

- 3rd the communication protocol is IP over a RAS/PPP dialup or direct network connection.

137
Views
0
Helpful
4
Replies
CreatePlease to create content