My customer has existing Waas appliances inline in regional/branch location to a pair of WAN routers. They are looking at a refresh, and want to know if an ISR with a UCSE blade and vWaas might be a more cost effective approach. They have a single appliance configured for fail-open, so my question is, can an ISR/UCSE provide the equivalent capability,using a double-wide blade with 2 ethernet ports, or would we either have to go to a one-armed approach, or else use a pair of ISRs in front of the WAN routers? (Insertion of UCSEbaldes into the WAN routers, or upgrading the WAN routers is not an option at present).
My assumption is that fail-open requires special relay hardware in the NIC, but I wondered if anyone else has faced a similar situation, and what their soluution was.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...