Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Issue in Tunnel re-establishment

Hi,

I successfully establised the IPsec between 2 end points which consistes of ASA followed by a router on both ends. Then i configured the GRE Tunnel between 2 end and configured OSPF. No problem in OSPF Neighbour formation. But, couple of issues

  1. When the Router reloads then the GRE is not establishing unless i execute the "clear xlate" on the ASA. when i clear the tunnel everything is working fine. Tunnel is back to normal
  2. Inorder to overcome the above issue I change the default tunnel mode to "tunnel mode ipip". The tunnel is reestablishing automatically when the router reloads and i dont have to clear the tunnel. But the OSPF is not working when "tunnel mode ipip" is used.

What could be the reason for this

Regards

Logesh

1 REPLY
Hall of Fame Super Silver

Re: Issue in Tunnel re-establishment

Hello Logesh,

you may want to post this in security -> firewall forum.

OSPF over GRE tunnel works, I never heard of OSPF over that other tunnel mode.

You should look for a solution that allows you to use GRE tunnel between routers.

Hope to help

Giuseppe

277
Views
0
Helpful
1
Replies