cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
822
Views
0
Helpful
10
Replies

Issue with a Cisco 2821-HSEC/K9

elias.manchon
Level 1
Level 1

Hello Folks!!

I have adquired a Cisco 2821 Security Bundle. I have conected a desktop computer with a straight-throught wire and I can see as the Lan Network fail intermittently. I have tested it with a cross-over wire and with other desktop and the problem is the same. The lan interface is disconnected and connected again intermittently.

Is possible that the interface GE0/0 is damaged.

Thanks in advance!!.

10 Replies 10

paolo bevilacqua
Hall of Fame
Hall of Fame

Very unlikely, try hardcoding duplex and speed.

Hi, Thanks by your response. I can see that the SYS PWR led is blinking, then it stops for a moment and the led's light is switched on, then it switch off and it starts again the same process.

I think that the problem is the proper device and not the network.

Have you connected to the router via serial console for initial configuration ?

If you have not done that, whatever the LAN port does, is irrelevant.

The console via serial show nothing!!.

One moment...!, I have removed the Compact Flash and now it's working. The Compact Flash was inserted when I unpcked the product.

Sorry, I had a mistake, it not works either.

I have got to enter via serial. I can see the next error during the boot:

****** ERROR detected on PCI0 Bus

****** Try RESEATING all modules in the system

****** pci0_int_cause 0x00000200,

****** pci0_err_addr 0x00023801, pci0_err_cmd 0x0000000A

****** PCI Target Abort

Do what it's suggesting you, open it and reseat all modules.

If still trouble, return to vendor.

Yes, I will do it.

Greetings!!, Thanks for help me.

You're welcome, please remember to rate useful posts with the scrollbox below.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: