Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Jumbo Frames and Flow Control across a WAN Link.

All, on our LAN we have Jumbo Frames and Flow Control enabled for our ISCSI SAN. We are wanting to replicate data from SAN1 to SAN2 across the WAN on an MPLS line. Do we need to enable jumbo frames on our MPLS routers to, or is jumbo packet removed when it goes across the router?

4 REPLIES
Silver

Re: Jumbo Frames and Flow Control across a WAN Link.

Hi,

The ability of the various Catalyst switches / routers to support various frame sizes depends many factors, including the hardware and software. Note that certain modules can support larger frame sizes than others, even within the same platform. Additionally, maximum frame size support can also change depending on the software version you use.

Go thro. this link

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_example09186a008010edab.shtml#configs

Rate if it does,

Rgs

Hall of Fame Super Gold

Re: Jumbo Frames and Flow Control across a WAN Link.

Hello,

Which router do you have? Only certain gigabit interfaces can support jumbo frames. Then, you have to ask your MPLS provider if they will carry them on their network.

New Member

Re: Jumbo Frames and Flow Control across a WAN Link.

we have a 2801 on one end and a 3800 on the other.

Hall of Fame Super Gold

Re: Jumbo Frames and Flow Control across a WAN Link.

The 38x5 does support jumbo frames, but the 2801 does not. So you are limited anyway.

As a recognition to those providing useful answers, please rate useful posts using the scrollbox below!

1779
Views
0
Helpful
4
Replies
CreatePlease to create content