just a small probem when changing administative distance
i am a student , i have three 2500 series router , serial connected r1 - r2 - r3 , and each router has three lan associated with each routers , i enabled both rip and igrp , then the routing table showed igrp router since the ad is low with rip , if i change the ad of igrp to 140 , then also igrp routes r shown , whats its cause , pls give me the exact command , thanks in advance
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...