Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

L2 and L3 connectivity

Hi ALL:

I have a 2 L3 switch which are connected to l2 Switch the L2 switch is again

connected to one more L2 and then to router.

I want to added a static route on both the L3 ,for which the next hop is router.

What configuration do i have to do on L3 and L2 switch for this to work.

L3---->L2---->L2----->Router

|

|

L3

L3 ARE CONNECTED TO EACH OTHER AS WELL AS TO L2.

Chao

Vishwa

3 REPLIES

Re: L2 and L3 connectivity

Are they all in the same subnet or the two L3's are seperated by a seperate L3 link?

Narayan

New Member

Re: L2 and L3 connectivity

Hi Narayan,

I am looking for a solution to pass my vlan x traffic to the router and all other traffic the the way it was going ,right now there is a default route pointing to the firewall on L3 for all the traffic the firewall is in between the L2 and for this solution i want to bypass the firewall as well so i have not inclued it in the diagram.

Chao

Vishwa

New Member

Re: L2 and L3 connectivity

Hi Vishwa ,

"IP helper" could be the best way for you or configure Static route to each device.

HTH

DAk

193
Views
0
Helpful
3
Replies