Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

l2tp question

Is l2tp possible between a 2821 and 6500 router? Could you provide the commands that need to be entered on the two sides? Are there any gotchas that I should be aware of about l2tp?

Everyone's tags (6)
5 REPLIES
VIP Purple

l2tp question

Hi Kashish,

Please check the link to configure:

L2TP with IpSec

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080093f6f.shtml

REgards

Please rate if it helps.

New Member

l2tp question

We don't need ipsec, just plain t2tp tunneling..

Just found that 6500 does not support l2tp, so now we are planning to run the tunnel between 2821 and 3845 routers. Could you please confirm if this setup is possible?

Thanks

VIP Purple

l2tp question

Hi Kashish,

yES this scenrio will work.

It is alwayas better to use encrypted tunnel to make secure.

Usually we are using gre TUNNELS WITH IPSEC:

Regards

Please rate if it helps.

New Member

l2tp question

Reason we are not using encrypted tunnels is because the tunnel will be between two departments and will go through internal network only. hence just l2tp should be fine.

VIP Purple

l2tp question

ok good,

just mark this question as answered...if are please with this.It may helps others.

Regards

please rate if it helps.

323
Views
0
Helpful
5
Replies