Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

L2TPv3 error

In configuring L2TPv3, I'm getting:

Jun 25 10:07:20.077: uid:43 Tnl/Sn 32862/8086 L2TP: Session state change from wait-connect to wait-for-service-selection-icrq

Jun 25 10:07:20.077: uid:43 Tnl/Sn 32862/8086 L2TP: Started service selection, peer IP address 192.168.7.1, VCID 77

Jun 25 10:07:20.081: uid:43 Tnl/Sn 32862/8086 L2TP: disconnect (L2X) IETF: 9/nas-error Ascend: 62/VPDN No Resources

The only reference I've found in searching was something that didn't really seem to apply to what I was working on. Does this sound like a lack of memory?

Thanks!

2 REPLIES
Hall of Fame Super Silver

Re: L2TPv3 error

Hello Steven,

the error message you see is telling you that the remote end has not resources to setup the VPDN service.

Are you sure that the remote end is the right one ? It could be a NAS server I also see that is an Ascend, however it may be a device that is not offering the service your device is asking for. So the service selection fails and it sends you a message.

This is my guess I may be wrong

Keep us informed if there is any progress

Hope to help

Giuseppe

New Member

Re: L2TPv3 error

Yes, I'm pretty sure now that it's a memory problem. I'm going to try and max out the memory on that router.

The error kind of threw me off. I'm not sure why it says "Ascend". It's a Cisco 3640. I don't think we have any Ascend devices on our network. The 3640 is configured almost exactly like the one on the central side.

Like I said, I'm going to add 32mb to that router and see what happens.

Thanks!

292
Views
0
Helpful
2
Replies