I've labed l2TPv2 over a WAN connection and it seems to work fine. So far I have only configured one VLAN to traverse the L2TPv3 tunnel. There are a couple of VLANs that I would like to send across the WAN. Could I configure several L2TPv3 tunnels(VLANS) off 1 interface - like a trunk? That way, I wouldn't need a new interface on the Headend router for every VLAN I wanted to get to another site.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...