Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

L2TPv3 pseudowire for T1 : BER test problems

Hi

  Could you help me with next issue?

I have 2 routers 7206 VXR (NPE-G2) with PA-MC-8TE1+ cards (both)

a L2tpV3 pseudowire was configure  between the routers using the T1's.

all my application works but when i try to check the T1 pseudowire link with a BER TEST, didnt pass!

Do you have information why I can't use a BER test over Pseudowire L2TPV3?

thank you

Rolando

Everyone's tags (4)
1 REPLY
Hall of Fame Super Silver

Re: L2TPv3 pseudowire for T1 : BER test problems

Hello Rolando,

L2TPv3 provides a point to point L2 transport for L2 frames.

BER may work at OSI layer1 so you cannot expect to perform a BER test over a link emulated by L2TPv3.

So what you see is not a real issue.

Hope to help

Giuseppe

484
Views
0
Helpful
1
Replies