Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

LACP using 2948G-L3

Hi,

I would like to ask if its possible to configure LACP between two 2948G-L3 over WiFi radio (other vendor)? The WiFi 5ghz radio was configured as transparent, and those two switches are 40Km apart. I wanted to configure LACP but I am not sure if it will work using WiFi radio. An immediate response is highly appreciated.

Thanks,

John De Jesus, CCNA

1 REPLY
Hall of Fame Super Silver

Re: LACP using 2948G-L3

Hello John,

if the devices in the middle don't stop the LACP messages that are multicast ethernet frames you should be able to do this.

Hope to help

Giuseppe

404
Views
0
Helpful
1
Replies
CreatePlease to create content