Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Layer 2 over L3 with loadbalancing, maybe challenging

Hi Experts,

i'm trying to accomplish the following:

(please look at the attached image).

I want to trasport a bunch of vlan layer 2 etherchannel on a pair of layer3 connections, using L3 to load balance.

i was considering a pair of options:

1) bridging + gre (non applicable since i cant bridge 2 interface beloging to a etherchannel to a tunnel)

2) L2TP

is it possible to accomplish this with the above tecnology? any reference, configuration example?

3) AoMLPS

is it possible to accomplish this with the above tecnology ? any reference, configuration example?

I cant modify topology, the routers used are ASR1001

It is mandatory that both sites have a layer2 connection between them.

If this is not the appropriate forum category, can you point me the correct one?

Andrea

1 REPLY
New Member

Layer 2 over L3 with loadbalancing, maybe challenging

to add further information, the etherchannel carry a dot1q trunk with a small set of vlan

Andrea

156
Views
0
Helpful
1
Replies
CreatePlease to create content