cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
835
Views
0
Helpful
1
Replies

Layer 3 etherchannel on 887 router

nicholas boran
Level 1
Level 1

                   Hello

I can't see any documentation to say an 887 will support layer 3 etherchannel configurations over two of it's fixed interfaces. Can I confirm this is standard, at this stage. This is a new deployment, so the latest hw version and software will be in use.

I have a test 887VAG2 here with 15.1(4) M4 and I don't see the required commands. Maybe it is done in a different way?

Thanks

Nick

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

The 887 does not have performances enough not evern to support a single fast ethernet, so that etherchannel at whatever layer, is out of scope for this small banch router.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco