Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

layer 3 port bandwidth usage

All,

How can I see a layer 3 port bandwidth usage? I have tried but it is not working.

Thanks,

30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
L3 in Switched: ucast: 54217685 pkt, 15613598253 bytes - mcast: 0 pkt, 0 bytes
L3 out Switched: ucast: 49891888 pkt, 12027617095 bytes - mcast: 0 pkt, 0 bytes
    54537044 packets input, 16667165219 bytes, 0 no buffer
    Received 279044 broadcasts (74600 IP multicasts)
    0 runts, 0 giants, 0 throttles
    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
    0 input packets with dribble condition detected
    50031279 packets output, 13048119837 bytes, 0 underruns
    44 output errors, 60 collisions, 0 interface resets
    0 babbles, 44 late collision, 0 deferred
    0 lost carrier, 0 no carrier
    0 output buffer failures, 0 output buffers swapped out

  • WAN Routing and Switching
2 REPLIES
Hall of Fame Super Silver

Re: layer 3 port bandwidth usage

Hello Yuhui,

what device is this? A multilayer switch I suppose it may be a cosmetic bug of your IOS image

Hope to help

Giuseppe

New Member

Re: layer 3 port bandwidth usage

Hi Giuseppe,

It is a cisco WS-C4948 (MPC8245) processor (revision 0) with 262144K bytes of memory running on cat4500-entservices-mz.122-46.SG.bin"

I had the same issue with 4507R-E running on cat4500e-entservices-mz.122-46.SG.bin

Thanks.

182
Views
0
Helpful
2
Replies
This widget could not be displayed.