Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LDAP Application not working with 2811 IOS 12.3(8)T11

Hi,

We are having LDAP application problem with 2811 router running 12.3(8)T11 image.

Before this application worked with 2621 router running 12.2(4)T3 and 12.1(5)T12

Note: There is no LDAP Query configuration in router, for LDAP just it pass through (it will do normal packet routing, configuration attached for reference).

Now we are hearing different suggestions from different people.

1 Some people are saying that "This LDAP application will work only with 12.1 and 12.2"

2 Some people saying that "It works only with 26xx series router".

3 Some people recommending to upgrade to latest IOS in 12.3 or 12.4 series.

I am requesting all technicins to put some comments on it.

Regards

Sivakondala Rao

1 REPLY
Hall of Fame Super Blue

Re: LDAP Application not working with 2811 IOS 12.3(8)T11

Hi

Does the router function normally for other traffic. If it is and you are merely routing the ldap traffic then it should make no difference which router you use. So this would point to other issues. Looking at your config 2 things jump out

1) NAT

2) access-lists

Could you send more details on source IP address and destination IP address and which direction on the router the ldap traffic flows.

Jon

192
Views
0
Helpful
1
Replies