Assuming that you want to bridge the Fa0/0 and Fa0/1 together on your router, the configuration shall be fairly simple:
bridge 1 route ip
bridge 1 protocol ieee
The question is - do you really need to configure the router as a bridge? If it only bridges two FastEthernet interfaces together without performing any other function then you probably do not need the router at all. What other services does this router provide?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...