In our setup,we have our leased line customers connected through our gig ethernet ,as sub-interface for each customer . we are controlling DSL and Dialup customers through billing , but for leased line customers we have to do some manual work if a customer disconnect /reconnect . Is there is any way to automate this ?
description customer A
encapsulation dot1Q 161 ip address 192.168.100.177 255.255.255.252
! interface GigabitEthernet0/3.2 description B
encapsulation dot1Q 524 ip address 192.168.100.197 255.255.255.252
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...