Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Legacy DDR

Hi

i have a project, an client has only 2 Public IP addresses, i want to use Network address Translation (NAT)and we want to Use legacy DDR to connect to the ISP with PPP encapsulation.

How can i achieve a better config/Setup for this project?

who face like this setup plz provide necessary info...

10xs for ur help

7 REPLIES

Re: Legacy DDR

Hi Sayed

You can configure something like Overload(PAT) to achieve your requirement.

You need to create inside and outside statements respectively.

Once you are done with the same do create an access-list permitting your local lan block to access any.

while creating the nat statement you need to make sure you are overloading onto the interface which connects you to the outside world..

also refer the below link for more info on the same..

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091cb9.shtml

regds

New Member

Re: Legacy DDR

Hi spremkumar!

10xs for ur reply.but what about the connection to internet Thr ISDN

10XS

New Member

Re: Legacy DDR

what is your connection type?

BRI/PRI and how you are dialing router to router or any numeber (to any RAS)?

New Member

Re: Legacy DDR

HI Mate!

we have BRI Interface and WE SHOULD lagacy DDR WITH Encap PPP

10XS

New Member

Re: Legacy DDR

Hi

any Help here regarding legacy DDR With ppp encap to ISP

10xs

New Member

Re: Legacy DDR

hi rajivrajan1

10xs for ur reply!

132
Views
10
Helpful
7
Replies
CreatePlease to create content