First of all I do not know if this is the right room to ask this question but here it goes...
I'm having a weird issue with legacy ISDN BRI link. I'm able to bring up the link (the call gets through successfully) but I can not ping the router's interface on the other end.
Please take a look at the .doc attachement I have upload here. There is debuging and troubleshooting information that indicates the layer 2 and layer 3 negotiation is accomplish , the isdn call status ACTIVE and a lot more..
At this point I have reload both routers (my end and the other end) I have shutdown (and no shut) BRI interfaces on both ends, restart ISDN switch on both ends but still CAN NOT ping the other router even though call gets trough.
ANY comments that help will be greatly appreciated!!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...