Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Light VPLS vs L2TPv3

Hi there,

I need to implement hub-spoke multipoint L2 bridging solution over non-mpls IP only enterprise network. Is there any light VPLs or similar technologies that I can use without implementing full blown MPLS. Is there any way to modify l2tpv3 to make it multi-point to bridge the same VLANs across WAN ?

thanks

SU

1 REPLY
Silver

Re: Light VPLS vs L2TPv3

hi

you can use l2tpv3 for point to point scenario. In case of point to multipoint , vpls is required because it uses the bgp signalling and the minimum requirement is 7600 with sip and spa card.

regards

shivlu jain

334
Views
0
Helpful
1
Replies
CreatePlease to create content