Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
787
Views
0
Helpful
1
Replies

Light VPLS vs L2TPv3

s.uslay
Level 1
Level 1

‎05-10-2009 10:36 PM - edited ‎03-04-2019 04:43 AM

Hi there,

I need to implement hub-spoke multipoint L2 bridging solution over non-mpls IP only enterprise network. Is there any light VPLs or similar technologies that I can use without implementing full blown MPLS. Is there any way to modify l2tpv3 to make it multi-point to bridge the same VLANs across WAN ?

thanks

SU

Labels:
0 Helpful
1 Reply 1

shivlu jain
Level 5
Level 5

‎05-11-2009 11:31 PM

hi

you can use l2tpv3 for point to point scenario. In case of point to multipoint , vpls is required because it uses the bgp signalling and the minimum requirement is 7600 with sip and spa card.

regards

shivlu jain

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card