Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Limit max bandwidth for many IP addresses concurrently

Hi,

    I need to limit the max bandwidth available for many IP concurrently.

I have four C classes and I don't want to write 1000 rate-limit commands.

I want that any IP address cannot exceed the limit of 10megabits.

This is for security reasons (DoS attacks and so on)

Regards

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Limit max bandwidth for many IP addresses concurrently

Disclaimer


The   Author of this posting offers the information contained within this   posting without consideration and with the reader's understanding that   there's no implied or expressed suitability or fitness for any purpose.   Information provided is for informational purposes only and should not   be construed as rendering professional advice of any kind. Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In   no event shall Author be liable for any damages whatsoever (including,   without limitation, damages for loss of use, data or profit) arising  out  of the use or inability to use the posting's information even if  Author  has been advised of the possibility of such damage.

Posting

It's platform specific (which you didn't mention), but session or UBRL policing might be what you might want.

1 REPLY
Super Bronze

Limit max bandwidth for many IP addresses concurrently

Disclaimer


The   Author of this posting offers the information contained within this   posting without consideration and with the reader's understanding that   there's no implied or expressed suitability or fitness for any purpose.   Information provided is for informational purposes only and should not   be construed as rendering professional advice of any kind. Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In   no event shall Author be liable for any damages whatsoever (including,   without limitation, damages for loss of use, data or profit) arising  out  of the use or inability to use the posting's information even if  Author  has been advised of the possibility of such damage.

Posting

It's platform specific (which you didn't mention), but session or UBRL policing might be what you might want.

290
Views
0
Helpful
1
Replies
CreatePlease to create content