Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Limit max calls based on DNIS on the PRI line

Hi,

I have the PRI line which has few DDI numbers. Is there any way that i could restrict the max number of simultaneous calls to the called DDI number?

lets say if the ddi number is ****123654 limit it to 5 calls. so max 5 concurrent calls can be landed to this number and the sixth call fail.

username DDI_Number user_maxlinks (number of connections)

I have tried the above command but its not working.

Can you please help me out?

Thanks

6 REPLIES
Hall of Fame Super Gold

Re: Limit max calls based on DNIS on the PRI line

What router is that and which IOS version ?

New Member

Re: Limit max calls based on DNIS on the PRI line

Sorry about missing this information

Its 5400XM dial rack with IOS version Version 12.4(25a),

Hall of Fame Super Gold

Re: Limit max calls based on DNIS on the PRI line

Check:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a0080094898.shtml

Please remember to rate useful posts clicking on the stars below.

New Member

Re: Limit max calls based on DNIS on the PRI line

HI,

I have the following config on 5400XM. Can you please tell me where and how can i implement the ' called-number 5557528 max-conn 3' command? I have few other Profiles on the 5400Xm same like below. modem-pool command is not available in AS5400Xm and AS5350Xm. Please help me out.

resource-pool group resource Profile-1
range port 1/0 1/59

resource-pool profile customer Profile-1
limit base-size 60
limit overflow-size 0
resource Profile-1 speech
dnis group DNIS-Profile-1
interface Group-Async0
ip unnumbered Loopback0
encapsulation ppp
async mode interactive
peer default ip address pool IPPOOL
ppp authentication chap pap callin
group-range 1/00 1/59

line 1/00 1/59
no motd-banner
no exec-banner
exec-timeout 0 0
no flush-at-activation
no vacant-message
modem InOut
modem autoconfigure type MODEMCAP
autocommand  telnet 192.168.168.2 /stream
no activation-character
transport input all
escape-character NONE
autoselect during-login
autoselect ppp
autohangup

Hall of Fame Super Gold

Re: Limit max calls based on DNIS on the PRI line

Search with the box above to see if the command has changed and how.

New Member

Re: Limit max calls based on DNIS on the PRI line

The command seems to be there but seems not acceptable when you have resource pools enabled. Is there any way i can accomplish this with the configuration i have provided above. It should be very simple but don't know how to do it.

272
Views
0
Helpful
6
Replies
CreatePlease to create content