Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

limited public IP addresses

I am looking at switching ISPs. Currently I have an abundance of public IP addresses, but if I switch I will only get 5. I know which servers I need to assign a public IP address. I also need to assign one to my firewall for NAT. Is there a way to not have one assigned to my router? Obviously, my Cisco 2524 router is on the public side of my firewall. The firewall is an MS ISA 2006 server, with the public NIC card currently configured with the gateway as my 2524 router.

3 REPLIES
New Member

Re: limited public IP addresses

If the router's interface is touching the ISP's public network, you're going to need one of their public IP's.

Why won't the ISP let you buy more? Have you checked with other ISP's?

Do all of your servers require external/public access to provide the same services (are they all web servers, etc.)? If not, you can split up inbound traffic on different ports to different internal/private IP's based upon whatever the server is doing (for example, you can use the same external IP on a firewall for a web server AND a physically separate SMTP server).

New Member

Re: limited public IP addresses

I am unsure how to split an IP. Would it be by the port #? Would it be done on the firewall? I seen this with cable gateway routers. Is it the same? I have been spoiled with all public IPs in the past.

I have two servers that use the same ports, the others do not. I have a web/ftp server in front of the firewall. I have two citrix servers and an SMTP server behind the firewall. I also need an IP for the router and the firewall. So, if I had 6 public IPs I would be fine.

This ISP is by far the cheapest around, fast, and reliable. They have a smaller pool of IPs the draw from.

New Member

Re: limited public IP addresses

You can direct inbound traffic by port in the firewall (at least that's what I've seen in Cisco and SonicWall) for servers inside the FW.

88
Views
3
Helpful
3
Replies
CreatePlease to create content