Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Line clocking information from Telco Mux

Hello there,

I am using the channelise E1 card, VWIC2-1MFT-G703 on my router. The line speed is 1M. Is there any command that I can use to check the actual line clocking speed received from the serial line?

I tried to used show controller s0/0/0:0....but, it did not tell me the line speed clocking received.

Thank you

166
Views
0
Helpful
0
Replies