Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Link down and Link Up Snmp trap C#

Hi i've configure my cisco router to receive the SNMP traps if the link goes up or down. However i found out that when i plugged out the cable i'm not receiving any link down on the network management system. Until i plugged in again the link will then show up or down state. May i know whats the reason why i can't receive the link down when i plugged out my cable?

Everyone's tags (3)
565
Views
0
Helpful
0
Replies
CreatePlease to create content