i want to configure some mitel handsets to use LLDP Med, i have a cisco 3750 configured with LLDP default and CDP turned off. I can plug a mitel phone into the port and the phone boots in the voice vlan, i presume this is because i have the (switchport voice vlan 20) command on the port.
Question how do i modify the network policy in LLDP so it instructs the phone that i want to use a diffserv value of EF. The default voice policy show 802.1p 0 and diffserv 0 on the show lldp entry command.
Did you manage to succeed with this? I know that you had said you could not use when configuring on a trunk but if you use the 'switchport voice vlan' command to assign the VLAN ID of the Voice VLAN this creates a 'special' dot1q trunk so you would then still be able to use the Network-Policy commands.
I have a customer who has some Mitel phones that they will be adding to their network and I have not used LLDP as of yet so wanted to check with you if it had done the job?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.