We have a 2921 using two Ethernet ports for dry DSL coming from a third party ISP. The ISP is stripping the usual DSL protocols and sending us only the Ethernet to this far end router. The near end router is being sent only on Ethernet connection from the third party ISP. We need to load balance by protocol over the two far end connections (A=1.2 MB, B=820 KB) to the single near end for VoiP and local services and Internet connectivity. Any insight to configuration documentation, commands and/or protocol recommendation would be appreciated. We are currently using EIGRP.
are the switches which connects ethernet circuits layer 3 ? is the ethernet link layer 3 in nature too ? how is your local LAN setup, with regards to data & voip ? have you segmented your network to different vlans ? where are the destination servers for data & Voice ? do you also want to load balance internet traffic ? Do you have any rough architecture diagram to show the connectivity ?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...