Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

load balance on 2911/k9

Helo,

Is it possivel configuring load balance with three intefaces, in my router with the following features?

I have three ISP, and would like balance the traffic ...

Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(2)T1, RELEASE SOFTWARE (fc1)

Cisco CISCO2911/K9 (revision 1.0) with 483328K/40960K bytes of memory.

Processor board ID FTX1613AH8D

3 Gigabit Ethernet interfaces

1 terminal line

2 Channelized (E1 or T1)/PRI ports

1 Virtual Private Network (VPN) Module

DRAM configuration is 64 bits wide with parity enabled.

255K bytes of non-volatile configuration memory.

250880K bytes of ATA System CompactFlash 0 (Read/Write)

Technology Package License Information for Module:'c2900'

-----------------------------------------------------------------

Technology    Technology-package           Technology-package

              Current       Type           Next reboot

------------------------------------------------------------------

ipbase        ipbasek9      Permanent      ipbasek9

security      securityk9    EvalRightToUse securityk9

uc            uck9          Permanent      uck9

data          None          None           None

Configuration register is 0x2102

Thanks!

Everyone's tags (2)
3 REPLIES
Hall of Fame Super Gold

load balance on 2911/k9

Cisco CISCO2911/K9 (revision 1.0) with 483328K/40960K bytes of memory.

Processor board ID FTX1613AH8D

3 Gigabit Ethernet interfaces

you need at least one more FE or GE interface, for example HWIC-FE or HWIC-2FE

and you can make load balance with BGP (not full view) or 3 static routes if all three ISP the same bandwith

Hall of Fame Super Gold

Re: load balance on 2911/k9


you need at least one more FE or GE interface, for example HWIC-FE or HWIC-2FE

and you can make load balance with BGP (not full view) or 3 static routes if all three ISP the same bandwith

No additional ethernet interfaces are needed, as one can use a switch and VLAN interfaces, or ADSL interface

Also note that not  everyone has BGP or the option of running it.,

1112
Views
0
Helpful
3
Replies