cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
859
Views
0
Helpful
5
Replies

Load balance on 3750 over 2 ISP

y.lo
Level 1
Level 1

I got 2 sites, both with 3750 installed and they are connected using 2 ISP. I found the command "ip load-sharing per-packet" is not supported on 3750. How can I distribute traffic evenly over the 2 links?

1 Accepted Solution

Accepted Solutions

Per-flow balancing, that is the optimal method.

Per-packet introduces out-of-order arrival and must be avoided.

Please remember to rate useful posts clicking on the stars below.

View solution in original post

5 Replies 5

paolo bevilacqua
Hall of Fame
Hall of Fame

You cannot, beside a 3750 is not apt for connecting to ISP.

So there is nothing we can do to make the situation better? Would disabling route cache help a bit?

Also, there seems to be a table that stores the destination address of traffic. Would this table has a timeout value? Thanks.

You have a L3 switch, there is no route cache and stuff like that.

The device is already operating at its best, if you want more options, get a true router.

Thanks for your reply. What if there are 2 or more optimal routes to the same destination network? How would it forward the packet?

Per-flow balancing, that is the optimal method.

Per-packet introduces out-of-order arrival and must be avoided.

Please remember to rate useful posts clicking on the stars below.

Review Cisco Networking products for a $25 gift card