Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

load balance problem

i have to connections on router 2600 i configured eigrp to load balance, they worked well for some times then after a while i found that load balancing is not working

even though CEF is enabled on both interfaces.and i put this command ip load share-per packet. also it is not working

note

when i type the command show ip eigrp neigbour

i found the two routes but still no load balancing.

the traffic is always going through one interface,traffic goes throgh the other interface only when i shutdown the first one

3 REPLIES
New Member

Re: load balance problem

Hi.

You check the bandwith value on the interfaces ?

The values need to be the same.

The input trafic is balanced ?

What kind of service are you using ?

Best Regards.

New Member

Re: load balance problem

bandwidth value on both interfaces is 2048.

and it is vpn connection

New Member

Re: load balance problem

95
Views
5
Helpful
3
Replies
CreatePlease login to create content