Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load Balance using MLPPP

hi guys,

my isp told me to use multilink ppp to load balance our connectivity to them. will these setup work ? i have 2 atm interfaces and bgp configuration. can you please give an examples on these.

thanks

jeff

2 REPLIES
New Member

Re: Load Balance using MLPPP

what encapsulation does your atm interfaces use? multilink ppp is useful only for ppp encap types. Maybe your ISP wants you to use Cisco proprieetary Bandwidth on Demand (BoD). Here is a sample.

int bri0

encap ppp

dialer map ip 10.1.1.1 name Aussie 8001234

dialer map ip 10.1.1.1 name Aussie 8005678

dialer load-threshold 1 either

this will dial your both B-channels to same destination using ISDB bri interface

New Member

Re: Load Balance using MLPPP

Hi,

Atm interfaces uses aal5snap encapsulation. Im checking these interface Multilink and virtual-template commamds here. No dialer map ...

122
Views
0
Helpful
2
Replies
CreatePlease login to create content