Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

load balance with multi exits on static route?

Greeting

I have only one default route 0.0.0.0 which configured as static route. I am currently trying to configure multi-homing.

Could I get advice, if I can configure second edge router using static route also, and this router can share the load with current one? I mean without BGP/EIGRP?

Any comments will be apprecated

Thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions

Re: load balance with multi exits on static route?

Yes you can

if you've two static default routes the router will do loadbalancing by default will be per session loadbalancing

which means session to ip x.x.x.x will use next hop 1

session to ip y.y.y.y will use next hop 2 and so on

if this is Internet links you may need to consider nating configurations

also you if you want to look for advanced ios features you may use pfr for loadbalancing with static routes

see the bellow document which wil help you to under stand some features that may apply to your case

https://supportforums.cisco.com/docs/DOC-8313


https://supportforums.cisco.com/docs/DOC-8353

good luck

if helpful Rate

1 REPLY

Re: load balance with multi exits on static route?

Yes you can

if you've two static default routes the router will do loadbalancing by default will be per session loadbalancing

which means session to ip x.x.x.x will use next hop 1

session to ip y.y.y.y will use next hop 2 and so on

if this is Internet links you may need to consider nating configurations

also you if you want to look for advanced ios features you may use pfr for loadbalancing with static routes

see the bellow document which wil help you to under stand some features that may apply to your case

https://supportforums.cisco.com/docs/DOC-8313


https://supportforums.cisco.com/docs/DOC-8353

good luck

if helpful Rate

3084
Views
5
Helpful
1
Replies
CreatePlease to create content