We have a situation where Radware Load Balancer is being used.
we have some servers kept in dmz zone which are exposed to internet by static natting method. These servers are being accessed from internal as well as from external.
there is a server kept in inside (which is a member of dmz zone, single server zone). this server also needs to be accessed from outside. This is accessed successfully from inside.
But this server is mapped with Radware Load Balancer Virtual IP. This VIP is mapped with 2 Physical IP. The server kept inside is not being accessed from outside. But if i map this internal server with LBR physical ip its happening. But customer's requirement is VIP mapping with the internal server.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...