Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load balancing and binding

We have a 6500 router with a CSM module for load balancing. Our current setup is to bind a subnet to a fiber port on the CSM. This was done to reduce the ability of spammers to abuse un configured subnets/ip's. Now we would like to add a non load balanced subnet to the same fiber port on the CSM. Basically we would like to have a switch with load balanced and non load balanced servers. However with our current setup this is not possible. Can this be done?

1 REPLY

Re: Load balancing and binding

Cant you do multiple vlans (one for NLB and one for LB) and configure the fiber port as a trunk to receive traffic for both vlans ?

91
Views
0
Helpful
1
Replies
CreatePlease login to create content