04-25-2008 11:10 AM - edited 03-03-2019 09:42 PM
My site router is connected to 2 remote routers thru Internet. Any ideas how can I set load balancing up if remote sites get their ip addresses from ISP's DHCP server?
04-26-2008 02:45 AM
Hi, look at the example:
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a0080950834.shtml
Keep the two default routes to have same weight if you want to load balance.
Hope this helps, please rate post if it does!
04-26-2008 08:52 AM
04-26-2008 09:44 AM
Sorry, can't see proprietary file format.
The remote router will have to begin the vpn via a dmvpn type setup.
You can also no not envrypt and just use poin-to-multipoint GRE with nhpr. This is also a DMVPN tecnique.
Then when you have routing information for the site over GRE tunnels, router will load share using the two lthat you will have set to be terminated at B and C. With dynamic routing, you will have redundancy as well.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide