We are having problem with load balancing in OSPf enabled network.
We have adjusted ospf cost of the destination network so that we can see show two routes of equal cost to the destination network in , show ip route command.
One path is via a serial link connceted to destination router and another path is via ethernet to another router which is turn has serial link to destination router. But when we check the link utilizations only one link was showing traffic and other link was free. Do we need to configure any thing more to load balance in OSPF when it has two paths of equal cost to destination network.
Any link on cisco.com for configuration example of load balance in OSPF is highly appreciable !
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...