I am trying to set up 2 DSL connections and a cable connection in my home. I have been looking at load balancing routers, including 1751. However, I connect to work through Cisco VPN (VPN client version 4.8.01.0300). Will this tunnel be load balanced?
On the 1751 router I can add multiple DSL WIC cards which are then load balanced, so this is only one router. Please explain if the VPN tunnel will be load balances between the DSL WICs on the 1751 router or why not. Thank you, Pat
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...