Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load balancing Wireless and serial link

Hi,

I have a router with 2 WAN connections, One 2 MB E1 terminated to serial link and another wireless link terminated to Ethernet. Is it possible to load balance between the two. If so how?

thanks in advance

Rajesh

2 REPLIES
Hall of Fame Super Blue

Re: Load balancing Wireless and serial link

Rajesh

Yes you should be able to do this. If the links are the same speed then a dynamic routing protocol could be used and as long as it saw both links to the same destination it would use both.

If the links are a different speed you could use 2 static routes one for each link. Bear in mind though that if one link is much faster than the other you may be better off using the slower link purely as a backup.

Jon

New Member

Re: Load balancing Wireless and serial link

Dear Jon,

Thanks a lot

rgds

rajesh

102
Views
5
Helpful
2
Replies