cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
294
Views
0
Helpful
4
Replies

load balancing

Just Kennie
Level 1
Level 1

Please i have two link on mi router through the WAN to the HQ. I wan to do load-balancing on the two links. I am using static routing through tunnel...how is this possible. Is PBR a better option?

4 Replies 4

royalblues
Level 10
Level 10

Can you post a little more detail about your network topology ?

However you can configure multiple static routes via each path to the destination for loadbalancing

Narayan

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Just,

I would try to do the following:

have two static routes for the tunnel destination pointing to the two WAN interfaces.

+

enable load-balancing per packet on the tunnel and physical interfaces

PBR shouldn't be able to perform load balancing directly you can provie a list of next-hop but it is an ordered one with the second used if the first is not available

Hope to help

Giuseppe

Yes you are right, have two static routes for the tunnel destination pointing to the two WAN interfaces. So how do i enable load balancing per packet on the tunnel on physical interfaces.

Hello Just,

use the following:

ip load-sharing ?

per-destination Deterministic distribution

>>per-packet Random distribution

in interface config mode

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: