Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

load balancing

I am using two WAN links on load balancing using EIGRP routing protocol. Now if I wanna determine how many sessions are created on each link. how should I determine that. If I wanna change the session of a particular IP to another Link, what should I do to acheive that.

3 REPLIES

Re: load balancing

Hi,

afaik there is no simple way of looking at different sessions over a particular not overloaded link.

To force a certain session down a particular link would require PBR. Though technically possible I would not opt for such a solution because of administrative overhead and potential performance issues.

May I ask, why you are concerned about this?

Regards, Martin

New Member

Re: load balancing

The problem I am facing is that whenever there is high latency or packet loss on a particular link, all the PC on to that link create problem such like slow access to resources over WAN. I wanna change the sessions over other link. How to chk how much sessions are on a particular link

Hall of Fame Super Blue

Re: load balancing

Hi

Well you could ip accounting although this will only show source and destination address and bytes transmitted not the port numbers so it won't give you session detail as such but it will give you client/server IP address and how much data is being transmitted.

Be aware there is obviously an overhead on the router by turning this on so you need to be careful.

As Martin said, the only way to make one session go over a specific link is to use PBR but this is not really what you want to be doing.

HTH

Jon

96
Views
0
Helpful
3
Replies
CreatePlease to create content