Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Load sharing

I have 8 E1 links.I want to equal per packet load sharing of that 8 links using static route.is it possible to loadsharing to that 8 links,if possibe what will be the command?pls help

1 REPLY
Hall of Fame Super Silver

Re: Load sharing

Hello Nur,

first of all you need to install 8 equal cost and AD static routes in the routing table.

Something like

ip route 0.0.0.0 0.0.0.0 ser0/0

ip route 0.0.0.0 0.0.0.0 ser0/1

ip route 0.0.0.0 0.0.0.0 ser0/2

ip route 0.0.0.0 0.0.0.0 ser0/3

ip route 0.0.0.0 0.0.0.0 ser0/4

ip route 0.0.0.0 0.0.0.0 ser0/5

ip route 0.0.0.0 0.0.0.0 ser0/6

ip route 0.0.0.0 0.0.0.0 ser0/7

Notice: that depending on the IOS version of device the maximum number of parallel static routes installed in routing table can be less then 8 see later about MLPPP that can solve this issue.

The limit for parallel static routes can be less then that for dynamic protocols like OSPF or EIGRP.

on all serial intefaces and on the lan interfaces you need to enable per packet load sharing.

ip load-sharing per-packet

However, the better results can be achieved using MLPPP that build a single L3 link and then has its own load balancing per packet procedures

Hope to help

Giuseppe

214
Views
4
Helpful
1
Replies
CreatePlease to create content