You don't say which type of hardware you are using ie. CSM, ACE etc. Regardless of this both types of device will support sticky sessions so you should be able to achieve what you want.
There is a dedicated forum for load-balancing etc. -> Data Center -> Application Networking. You will get answers to your questions a lot quicker in that forum as that is where the relevant experts are.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...