Loading Balacing on Router

[Jaime MATEUS Gomes]

I have two links of internet coming from diferents TELCO companies. Can I dritibuted my traffic on these links using 70% of bandwith and 30%?

Witch protocol or feature my router must perform to reach that. What other ways i can do this?

Thank you

[Wilson Samuel]

Hi,

There are a couple of ways to achieve the same, I'm listing some of them as below:-

1. Buy a Radware device and it will take all the burden and you neednt do anything.

2. Run BGP and manage the traffic with the help of a device from FCP

3. Run GLBP and that will help to an extent.

HTH,

Regards,

Wilson Samuel

[Anand Narayana]

Hi,

you can also configure Policy Based Routing(PBR) on the cisco Router. find the document attached on "how to configure PBR?"

[paolo bevilacqua]

Actually there is no need for either BGP, PBR or radware to balance unequally, if you are suing NAT.

Just configure some selective supernet routes like 200.0.0.0 /7

And that will make a pseudo-balancing to work. It is up to you to find the right set of destinations that attains your goal of 30% on one link.

Hope this helps, if it does please rate this post!