Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Loading Balacing on Router

I have two links of internet coming from diferents TELCO companies. Can I dritibuted my traffic on these links using 70% of bandwith and 30%?

Witch protocol or feature my router must perform to reach that. What other ways i can do this?

Thank you

3 REPLIES

Re: Loading Balacing on Router

Hi,

There are a couple of ways to achieve the same, I'm listing some of them as below:-

1. Buy a Radware device and it will take all the burden and you neednt do anything.

2. Run BGP and manage the traffic with the help of a device from FCP

3. Run GLBP and that will help to an extent.

HTH,

Regards,

Wilson Samuel

Re: Loading Balacing on Router

Hi,

you can also configure Policy Based Routing(PBR) on the cisco Router. find the document attached on "how to configure PBR?"

Hall of Fame Super Gold

Re: Loading Balacing on Router

Actually there is no need for either BGP, PBR or radware to balance unequally, if you are suing NAT.

Just configure some selective supernet routes like 200.0.0.0 /7

And that will make a pseudo-balancing to work. It is up to you to find the right set of destinations that attains your goal of 30% on one link.

Hope this helps, if it does please rate this post!

108
Views
3
Helpful
3
Replies