My problem is the following. I have 2811 router with 256MB of RAM and 64MB of flash memory, loaded with IOS 12.4(3g). It has CME 3.3 up and running and generally it works OK.
But my problem began when I wanted to upgrade IOS with newer IOS due to upgrade from CME v3.3 to v4.x.
Namely, when I started copying a new IOS image from tftp server to router's flash, it failed.
Everything was normal (with copying) when it started to load, but when it was about to finish (98% was loaded to flash), suddenly it changed exclamation marks "!" for "O" letter (like this ...!!!!!!!!!!!!!!!OOOOOOOOOOOO....) and that was the end of process.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...